1. Read these instructions prior to operating the unit. For the most up-to-date manual, visit www.
violetdefense.com/resources.
2.
Heed all warnings. Failure to use the equipment in the manner specified may impair the unit from
providing the desired protection.
3. THIS EQUIPMENT IS DESIGNED FOR USE WITH GERMICIDAL LAMPS OR UV SOURCES. STRICT
ADHERENCE TO THE INSTALLATION DIRECTIONS IS NECESSARY TO PREVENT OCCUPANT
EYE AND SKIN EXPOSURE TO HARMFUL RADIATION.
4. This equipment is designed for use with germicidal UV radiation sources and must be installed
in compliance with competent technical directions to prevent risk of personal injury from UV
radiation.
5. UV radiation can pose a risk of personal injury. Overexposure can result in damage to eyes and
bare skin. To reduce the risk of overexposure this equipment must be installed in accordance with
the manufacturer’s site planning recommendations, including instructions on relative location
of each germicidal system component, the minimum distances between UV-generating devices
and other objects or surfaces, and protection from line-of-sight exposure to UV radiation in
unoccupied spaces located above the equipment mounting area (e.g. upper floor balconies, open
staircases, etc.).
6.
UV and optical radiation can be reflected by surrounding surfaces such as ceilings and walls. Since
reflective properties of surfaces can vary widely, it should be considered as part of site planning.
Follow the manufacturer’s recommendations for selecting appropriate ceiling and wall finishes.
7. IT IS THE RESPONSIBILITY OF THE INSTALLER TO ENSURE THAT PERSONS WILL NOT BE
EXPOSED TO EXCESSIVE UV OR OPTICAL RADIATION DURING EQUIPMENT OPERATION. THIS
WILL REQUIRE THE INSTALLER TO CONDUCT AN ASSESSMENT OF ALL SITE AND EQUIPMENT
SAFEGUARDS TO ENSURE THE SYSTEM IS OPERATING IN ACCORDANCE WITH THE SYSTEM
MANUFACTURER’S INSTRUCTIONS, INCLUDING AN ASSESSMENT OF IRRADIANCE OR
ILLUMINANCE LEVELS IN THE SURROUNDING OCCUPIED SPACES.
8. Equipment should be mounted in locations and at heights where it will not readily be subjected to
tampering by unauthorized personnel.
9. Equipment contains no user serviceable components. Contact Violet Defense for service.
Maintenance and servicing of this UV generating equipment shall be performed by authorized
personnel. Service personnel must wear appropriate Personal Protective Equipment (PPE) if the
equipment will be in operation during the maintenance or servicing work. Contact the equipment
manufacturer for PPE recommendations and guidance.
10. The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition.
11. Do not use this equipment for other than intended use.
12. Plug unit into a grounded outlet. Ensure proper conditions for operation. The unit is designed
to operate under normal conditions indoors (temperature 5-40 degrees Celsius, RH less than
80% (non-condensing), at an altitude <2000m and main supply fluctu/- 10% of nominal
voltage, overvoltage Category II.
13.
Allow unit to complete pre-programmed cycles prior to unplugging or shutting off power. This
allows it to enter safe mode.
2
