INSTALLATION - DROP CEILING WITH EXISTING OUTLET*
VANTAGE I UNIT WITH 2’ X 2’ ADAPTER
1. Remove the existing ceiling tile.
2. Make electrical connections to the electrical
junction box (Black to Black, White to White, Green
to Green)
3. Secure the unit using tie wires following proper
electrical and building codes.
4. Position the Vantage unit with adapter plate onto
ceiling grid.
To install in a 24” x 48” grid, cut the ceiling tile to fit
using a box cutter or appropriate tool. Insert cut-to-
size ceiling tile to sit flush against the Vantage unit.
1. Remove the existing ceiling tile.
2. Make electrical connections to the electrical
junction box (Black to Black, White to White, Green
to Green)
3. Measure and mark a 5 3/4” section on the ceiling
tile.
4.
Use a box cutter or other appropriate tool to cut off
the 5 3/4” section of the tile.
5. Secure the unit using tie wires following proper
electrical and building codes.
6. Position the Vantage unit onto ceiling grid.
7. Install a cross-bar adjacent to the unit.
8.
Insert the cut-to-size ceiling tile to sit flush against
the Vantage II unit.
INSTALLATION - DROP CEILING WITH EXISTING OUTLET*
VANTAGE II UNIT
INS
TALL
ATION
© Copyright 2021 Violet Defense, LLC All Rights Reserved
VNTG-USRMNL-2021
13
*Installation in ceiling applies only to the flex conduit version of Violet Defense
products. Please consult with a licensed electrician to ensure installation is
completed in compliance with the National Electrical Code (NEC). If an electrical
junction box is not present, consult a licensed electrician for installation of a
proper voltage junction box in accordance with NEC standards.
Installation should be performed by qualified service personnel only.
