HS-105P
Maintenance And Repair
4-12
User Manual
Motor Drive Fuses
To protect against over current conditions, a polymer “fuse” is inserted in series
with the positive drive wire to the pan and tilt motors - see the wiring diagram on
page 8. In normal operation, with a short term over current, the resistance of the
“fuse” increases to reduce the current through the motor. When the over current
is removed, the “fuse” return to its normal low resistance.
However, if a long term over current exists (or repeated over current conditions),
the polymer “fuse” may eventually fail. This is more likely to occur in the tilt
drive where an unbalanced load will cause the drive current to be higher than
normal. The pan drive circuit is identical, but rarely suffers a fuse failure.
Tilt Fuse Failure
The first indication of a tilt fuse failure will occur during indexing at power up.
If the tilt fuse is open circuit, the pan axis will find its shutter and index pulse as
normal. Then, when the tilt axis is supposed to search for its shutter, there will
be no tilt motion due to the blown fuse. However, the pan axis will be still be
moving as it mimics the demand for tilt search. The pan axis will move slowly at
first, then more slowly for a few degrees, then starts to drift until it reaches the
end stop microswitch.
You can confirm that the problem is with the tilt axis by pushing gently on the
tilt cradle at power up to see if the servo is locked. If the cradle moves easily
when you push it, the tilt servo is not operating to hold the cradle in position. A
possible cause is a tilt fuse failure.
Tilt Fuse Replacement
1.
Use a 3/32” hex key to remove the 7 screws from the tilt motor cover.
Motor Cover
Remove 7 Screws
Summary of Contents for HS-105P
