9
904107 REV C 4/13/15, INST 69 FIREBIRD w/o AC CNTRL PNL PG 9 OF 17
Wht
Wht/Grn
Red
Off/Hi Slide Pot Assembly
Step In
Slide Pot
Housing
Wire
Jacket
Tie Wrap
21301-VUP
Slide Pot
Clamp
491010-VUR
Slide Pot Assembly
112002-SUA
Wire
Jacket
Tie Wrap
Figure 8
Figure 8a
Off/Hi Slide Pot Assembly Installation (Cont.)
1.
Locate the control panel wiring harness, and plug the corresponding wire into the correct slide pot assembly
as shown in Figure 8, below.
2.
Once the wire is correctly plugged into the slide pot assembly, secure wire to the slide pot assembly using
tie wraps (supplied) (See Figure 8a, below). The tie wrap must be located between the end of the wire
jacket and the step in the slide pot housing, forcing a bend in each wire as it passes over the step in the
slide pot housing. The Head of the tie wrap must fall on the edge of the housing, as shown, to remain tight.
Ensure that the tie wraps are snug enough that the wires cannot move (See Figure 8a, below).
Force Bend Wires
Over Step
Summary of Contents for Firebird 1969
Page 17: ......
