14
901155 REV A 2/22/10, INST 1962-65 NOVA EVAP PG 14 OF 23
PLACE THE DRIVER SIDE LOUVER HOUSING UNDER THE DASH, ALIGN 1” FROM THE FRONT EDGE OF THE DASH
AND MARK MOUNTING HOLES. DRILL 7/64“ MOUNTING HOLES IN BOTTOM OF THE DASH. SEE FIGURE 11 BELOW.
PLACE THE CENTER /PASSENGER SIDE LOUVER BEZEL UNDER THE DASH AND, ALIGN 1” FROM THE FRONT
EDGE OF THE DASH AND MARK MOUNTING HOLES. DRILL 7/64“ MOUNTING HOLES IN BOTTOM OF THE DASH
AS SHOWN BELOW.
USING (2) #8 x ½” PH PAN HEAD SCREWS INSTALL THE DRIVER SIDE LOUVER HOUSING UNDER DASH AS SHOWN
BELOW.
USING (2) #8 x ½”PH PAN HEAD SCREWS INSTALL THE CENTER/PASSENGER SIDE LOUVER BEZEL UNDER DASH,
AS SHOWN BELOW.
INSTALL LOUVERS IN DRIVER SIDE HOUSING AND CENTER/ PASSENGER SIDE LOUVER BEZEL AS SHOWN IN
FIGURE 11a BELOW.
ONCE THE LOUVER ASSEMBLY IS IN PLACE, ROUTE THE DUCT HOSES AND ATTACH THEM TO THE CORRECT
LOCATION ON EVAPORATOR AS SHOWN IN FIGURE 13, PAGE 16.
UNDER DASH LOUVER INSTALLATION
(2)#8 x
½
PH
PAN HEAD
SCREWS
(2)LOUVERS
PASSENGER
SIDE
DRIVER
SIDE
(2)#8 x
½
PH
PAN HEAD
SCREWS
DRIVER SIDE
HOUSING
FIGURE 11
FIGURE 11a
(2)BALL
LOUVERS
