10
901155 REV A 2/22/10, INST 1962-65 NOVA EVAP PG 10 OF 23
ON A WORK BENCH, INSTALL EVAPORATOR REAR BRACKETS AND HARDLINES WITH PROPERLY LUBRICATED
O-RINGS. (SEE FIGURE 8, PAGE 11, (FIGURE 14, PAGE 17)
INSTALL FRONT MOUNTING BRACKET ON EVAPORATOR USING (2) 1/4-20 x
½
HEX BOLTS AND TIGHTEN AS
SHOWN IN FIGURE 5 BELOW.
REMOVE OEM FIRWALL PAD RETAINER PLUG.
LIFT EVAPORATOR UNIT UP UNDER THE DASHBOARD. SECURE LOOSELY TO THE FIREWALL FROM THE ENGINE
COMPARTMENT SIDE USING (2) 1/4-20 NUT w/ STARWASHER AND FLAT WASHER. SEE FIGURE 6 BELOW.
NOTE: TO ENSURE PROPER DRAINAGE, IT IS VERY IMPORTANT THAT THE EVAPORATOR IS LEVEL, BOTH LEFT-RIGHT
AND FORE-AFT. CHECK FOR LEVEL ON THE FLAT PORTIONS OF THE CASE AROUND THE DRAIN, BLOCK THE UNIT
UP, THEN DRILL FOR FRONT BRACKET SCREWS.
USING (2) #14 x
¾
SHEET METAL SCREW SECURE THE FRONT EVAPORATOR MOUNTING BRACKET TO THE INNER
COWL. SEE FIGURE 6a BELOW.
VERIFY THAT EVAPORATOR UNIT IS LEVEL AND SQUARE TO THE DASH, THEN TIGHTEN ALL MOUNTING BOLTS.
(NOTE: TIGHTEN THE BOLT ON FIREWALL FIRST, THEN THE FRONT MOUNTING BRACKET SCREWS.)
EVAP FRONT
BRKT
643076
PASSENGER SIDE EVAP
MOUNTING HOLE
REMOVE OEM
RETAINER
PLUG
INNER COWL
DRILL (2)
⁄
” HOLES
(2)#14 x
¾
”
SHEET METAL
SCREWS
VIEW FROM
PASSENGER SIDE
INSIDE OF CAR
(2) 1/4-20 NUT w/ STAR WASHER
AND FLAT WASHER
FIGURE 5
FIGURE 6
FIGURE 6a
EVAPORATOR INSTALLATION
(2)1/4-20 x ½”
HEX BOLT
DRIVER SIDE EVAP
MOUNTING HOLE
