9
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
LIGHT
To control the inner light turn on/off.
UP
Used to raise (warm) the set temperature by 1°C or 1ºF.
DOWN
Used to lower (cool) the set temperature by 1°C or 1ºF.
ºF/ºC
Selector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature
from Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold
mark for 5 seconds.
KEY LOCK
If in 2 minutes without touching any key, the controls will be locked automatically. To release the lock,
touch the
and marks at the same time for at least 5 seconds.
TEMPERATURE ZONES
The wine cooler has two temperature zones with a temperature range of 40°-72°F. The recommended
temperature setting for each zone is:
Lower Zone
between 55°-72°F (Ideal for red and white wines)
Upper Zone
between 40°-55°F (Ideal for sparkling and white wines)
NOTE:
The temperature set for the Lower Zone must always be the same or higher than the
temperature set for the Upper Zone. For optimal performance, the set temperature of the two zones
should differ by at least 4°F.
SETTING A TEMPERATURE
Touch
SET
to set the internal temperature for each zone. The degrees indicators will appear in
the display window marked
for UPPER ZONE and
for LOWER ZONE.
When you touch
SET
for the first time, the LED readouts will show the original temperature
settings (preset factory setting for UPPER ZONE is 10ºC / 50ºF and for LOWER ZONE is 16ºC /
60ºF).
Touch
SET
once. The left LED indicator for UPPER ZONE will flash. Then touch
UP
or
DOWN
to set the desired temperature.
When you touch
SET
again, the right LED indicator for LOWER ZONE will flash. Then proceed to
touch the
UP
or
DOWN
to set the desired temperature for the LOWER ZONE.
The temperature will increase by 1°C or 1ºF if you touch
UP
once, or the temperature will
decrease by 1°C or 1ºF if you touch
DOWN
once.
To view the set temperature in either zone at any time, touch
UP
or
DOWN
and the set
temperature will temporarily flash in the LED display for 5 seconds. You can touch
SET
to view
the temperature setting from one zone to the second zone.
NOTE
: When using the unit for the first time or after a long period of inactivity, there may be a
variance of a few degrees between the selected temperature and the temperature indicated on the
LED readout. This is normal due to the length of inactivity, and will correct itself after the unit is run for
a few hours. If the unit is unplugged, has lost power or is turned off, wait 3 to 5 minutes before
restarting the unit. The unit will not restart before this time delay.
