8
8
W W W . V I N O T E M P . C O M
INSTALLATION
Remove all packing material before using your wine cooler.
IMPORTANT
: Before connecting the unit to a power source, let it stand upright for approximately
24 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water and a soft cloth.
This unit is designed for freestanding and indoor use only. Position the unit in a dry and well-
ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below
60°F.
For free standing installation, 5 inches (127mm) of space between the back and sides of the unit
are necessary, which allows the proper air circulation to cool the compressor and condenser for
energy saving. Even for built-
in installation, it is a must to keep ¼” (6.35mm) space on each side
and at the top. And the air vent at the front of the appliance must never be covered or blocked in
any way.
Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To
level the wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 72°-78°F. If the ambient temperature is above or below
recommended temperatures, the performance of the unit m ay be affected.
It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
Avoid locating the unit in moist areas.
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
OPERATING YOUR WINE COOLER
CONTROLS
c
F
POWER
To control this appliance turn on/off. To turn OFF the appliance, touch the
and
marks at the
same time for 5 seconds.
SET
To set or view the internal temperature setting for each zone.
