SEAT
RESCUE
PILATUS PC-7 DECAL SHEET
SEAT
Note: Cut out the stickers and apply them in the proper area. Do
not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors.
Arrange sticker on model and when satisfied adhere the corner
without backing.
Carefully peel back the rest of the backing while at the same time
adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture
sticker (center of bubble) but not model surface with the
tip of the knife or sharp pin and squeeze out the air.
At curves stretch sticker and apply a little heat so that no ceases
occur.
Cut off the excess that is produced.
See the top of the box for apply the stiker
22- Sticker
Wing center section
DO NOT try to fly an out-of-balance model !
73mm
Note: If necessary, move the battery pack or add weight to either
the tail or nose until the correct balance is achieved.
RUDDER / SEITENRUDER
ELEVATOR / HOHENRUDER
AILERON / QUERRUDER
32mm (1.25”)
32mm (1.25”)
9mm (23/64”)
9mm (23/64”)
6mm (15/64”)
6mm (15/64”)
23- Balance
24- Control Surface
IMPORTANT: Flying your model at these throws will provide you with the greatest chance for successful first flight.
If, after you have become accustomed to the way the PC-7 flies, you would like to change the throws to suit your taste that is fine. However,
too much control throw could make the model difficult to control, so remember, “ more is not always better”.
WARNING:
RESCUE
RESCUE
For PC-7 Austria Air-force version
For PC-7 Swiss Air-force version
