VINCENT SV-122, Instructions For Use Manual

Page: 59 / 96

Vincent
59
A Accttiio onn B Buutttto onn((ss)) D Deessccrriip pttiio onn
Choose the RDS tuner
as input source
IIN NPPU UTT
S SEELLEEC CTTO OR R
((9 9))
TTU UN NEER R ((2 24 4))
S SEETT ((3 38 8))
To select the tuner push the „TUNER“ button on the remote control or
use the „INPUT SELECTOR“ at the front panel. On the remote control,
the “SET” buttons can also be used to change to the “TUNER“ input.
Choose
frequency
band
A AM M//FFM M
((8 8))((2 25 5))
Use these buttons, located at the front panel or on the remote control,
to switch between AM and FM mode. FM offers better sound quality
and a greater variety of radio stations.
Change between
stereo and mono
radio reception
S STT//M MO ON NO O
((8 8))((2 27 7))
This button, located at the front panel or on the remote control, enables
or disables the mono reception. This could be useful if a radio station's
signal is weak. Then sometimes the sound quality is better in mono.
Choose a station
by scanning the
frequency band
TTU UN NIIN NG G
M MO OD DEE ((8 8))
TTU U..M MO OD DEE
((3 30 0))
TTU UN NIIN NG G
PPR REES SEETT ((8 8))
TTU U//PPR R
((3 32 2))
With the tuner selected as input, press the button “TUNING MODE”
at the front panel or “TU.MODE“ on the remote control to select of all
three possible options one of the following two:
•
MANUAL
stepping through the frequencies by steps of 50 kHz
(FM) and 9 kHz (AM) )
In this mode, the buttons TUNING PRESET at the front panel and
the buttons TU/PR on the remote control can be used to step
manually through the frequency band. The display (2) shortly shows
“TNR MANU”.
•
AUTO
automatic frequency scan
In this mode, when the buttons TUNING PRESET at the front panel
and the buttons TU/PR on the remote control are pressed, a
frequency scan is started, it stops at the next frequency with a strong
enough radio signal. The display (2) shortly shows “TNR AUTO”.
Choose a station
by entering the
numerical frequency
value
D DIIR REEC CTT
((8 8))((2 28 8))
Z Za ahhlleenntta asstteenn
((8 8))((2 26 6))
Press the button “DIRECT” the receiver then waits for the input of a five
digit number (on the number pad) that represents the frequency with two
internal decimal places. If an invalid frequency is entered, “ERROR”
appears in the display (2).
TUNER