Vincent
53
Front speaker
If the front speakers are able to transmit the complete audio frequency spectrum
or if no subwoofer will be installed, choose “L”, otherwise choose “S”.
Center speaker
L (large Center speaker) - S (small Center speaker) - N (no Center speaker)
Surround speakers
L (large Surround speakers) - S (small Surround speakers) - N (no Surroundspeaker)
Subwoofer
Y (Subwoofer used) - N (no Subwoofer used)
If no button is pressed for some seconds, the normal operation mode (display of currently selected source
input) is entered again. While settings mode is still active, the following settings can be made using
„
MULTI CONTROL
“ (9) or the „
SET
“ buttons (38) on the remote control.
By using the button „
SPEAKER
“ (6)(39) you select speaker categories, parameters can be changed using
the knob „
MULTI CONTROL
“ (9) or the remote „
SET
“ buttons (38). The settings mode will be left auto-
matically. Make your settings as described in the following:
If the „5.1 CH INPUT“ is currently selected, it is not possible to change these settings.
All Speaker settings are „global“, they have effect on all source input channels except
„5.1 CH INPUT“ and in all sound playback modes.
Normal
operation
Display of
selected input
source
SPEAKER
MASTER
CONTROL/SET
FRONT
CENTER
SURROUD
(Surround)
S: small
L: large
N: none
S: small
L: large
N: none
S: small
L: large
Y: yes
N: no
These settings influence the distribution of the source signals to the different speaker channels. Since every
surround sound system needs „bass management“ to bring bass frequencies from specific or all channels
to those speakers that are best adapted for the reproduction of those, it is necessary to give the receiver
information about the kind of speakers used.
As „SMALL“ speakers all speaker models without nameable bass (frequencies below 80 Hz) playback abi-
lity are declared, irrespective their size. „LARGE“ speakers are all used speakers that have the ability to
playback low bass frequencies. No speaker („NONE“) means that it is not used in the system. If, for exam-
ple, no rear surround speakers have been installed, the required setting is „NONE“.
At any time in normal operation you can enter the speaker configuration menu pressing „SPEAKER“
(6)(39). Do this after first installation and everytime you add, remove or exchange speakers.
SUBWOOF
(Subwoofer)
1 SPEAKER CONFIGURATION („SPEAKER“ BUTTON)
