INSTALLATION INSTRUCTIONS
Hydrosense ID Addressable Water Detection System
Document Part No. 3500039 Issue:01
Page | 12 of 32
It will not be possible to perform the Autolearn sequence or transfer a configuration into the panel
from the PC (as described below) unless the configuration memory is “Write Enabled”.
It is also necessary to operate the “Write Enable” switch whenever any changes are made to the configuration
memory using the Access Level 3 “Edit Configuration” or “Set Times” menu options via the front panel controls.
8.2. Configuring the Panel (Autolearn – Initial Startup)
When supplied, the panel will contain no configuration and when power is first applied the display will show:
CAREFULLY slide the “Write Enable” slide switch (located behind the aperture in the bottom right corner of the
plate) to the left position using a small screwdriver, or similar tool. Then press the internal “Reset” switch that
can be seen through the hole in the plate with a small terminal screwdriver or similar tool.
The display will then show:
Followed by
Initialisation can take a few minutes to complete and the larger the number of devices on a loop the longer it
takes.
At the end of the initialisation process, if there are no faults, and after the “Write Enable” switch has been
CAREFULLY switched to the right position (using a small screwdriver or similar tool) the normal display will be
shown as below.
***WARNING***
WRITE ENABLE SWITCH IS OFF
THE SYSTEM IS HALTED
SET WRITE ENABLE AND RESET THE SYSTEM
RE-INITIALISING PANEL
PLEASE WAIT...
INITIALISING LOOPS, PLEASE WAIT
LOOP NUM. DEVICES INIT. PROGRESS
1 000 0%
