10.3. SIMPLIFIED DOUBLE LEAF learning procedure WITHOUT deceleration.
1. Begin the procedure with the gate closed.
2. Adjust trimmer TR3 SL to the maximum setting (complete clockwise rotation), thereby excluding deceleration.
3. Press push button P1 and hold it down until LED DL7 starts to flash (1
st
flashing frequency).
4. Release push button P1.
5. Follow the programming phases shown in the figure.
6. Programming ends when LED DL7 stops flashing.
CAUTION: After resetting or powering the board, the travel time of the first closing manoeuvre increases by approximately 5 seconds to allow the
completion of motion in any case.
1
st
START
The first START begins the
learning process by moving
MOTOR 1 in opening
(Caution! start with the
gate closed)
4
th
START
The fourth START sets the
MOTOR 2 travel end and
should be pressed when
leaf 2 reaches the stop
2
nd
START
The second START sets
the MOTOR 1 travel end
and should be pressed
when leaf 1 reaches the
stop
5
th
START
The fifth START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
3
rd
START
The third START sets the
MOTOR 2 travel end and
should be pressed when
leaf 2 reaches the stop
To complete programming,
wait for the gate to be
completely closed and LED
DL7 to be off
32
SW230.T / SW230.T.120
EN
