10.2. COMPLETE DOUBLE LEAF learning procedure WITH deceleration.
1. Begin the procedure with the gate closed.
2. Press push button P1 and hold it down. LED DL7 starts to flash (1
st
flashing frequency).
3. Do not release push button P1 until it flashes faster (2
nd
flashing frequency
4. Release push button P1.
5. Follow the programming phases shown in the figure.
6. Programming ends when LED DL7 stops flashing.
CAUTION: After resetting or powering the board, the travel time of the first closing manoeuvre increases by approximately 5 seconds to allow the
completion of motion in any case.
1
st
START
The first START begins the
learning process by moving
MOTOR 1 in opening
(Caution! start with the
gate closed)
8
th
START
DECEL.ZONE CL. M1
The eighth START sets the
starting point of MOTOR 1
closing deceleration
2
nd
START
DECEL.ZONE OP. M1
The second START
sets the starting point
of MOTOR 1 opening
deceleration
9
th
START
The ninth START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
3
rd
START
The third START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
10
th
START
The tenth START starts
the leaf delay learning
by moving MOTOR 1 in
opening
4
th
START
DECEL.ZONE OP. M2
The fourth START sets the
starting point of MOTOR 2
opening deceleration
11
th
START
M2 LEAF DELAY DURING
OPENING
The eleventh START starts
MOTOR 2 after the desired
leaf opening delay
5
th
START
The fifth START sets the
MOTOR 2 travel end and
should be pressed when
leaf 2 reaches the stop
12
th
START
The twelfth START starts
MOTOR 2 to learn the leaf
closing delay
6
st
START
DECEL.ZONE CL. M2
The sixth START sets the
starting point of MOTOR 2
closing deceleration
13
th
START
M1 LEAF DELAY DURING
CLOSING
The thirteenth START
starts MOTOR 1 after the
desired leaf closing delay
7
th
START
The seventh START sets
the MOTOR 2 travel end
and should be pressed
when leaf 2 reaches the
stop
To complete programming,
wait for the gate to be
completely closed and LED
DL7 to be off
31
SW230.T / SW230.T.120
EN
