VIDEO SIGNAL STABILISATOR
On the monitor intercommunication card
there is a connector (A-B-C) and a jumper
for the video signal balance (Fig. 9). This
jumper must be used on the installations
where there are more appliances (inter-
phones or monitors) connected in series
(Fig. 8).
Displace the jumper into “B” (Termination
100 Ohm) only on the last set and keep
the jumpers on the other appliances in
the initial position “A” (No termination).
For other connection configurations see
the: TERMINATION TABLE FOR THE
TWO WIRE ELVOX INSTALLATIONS”
shown in the wiring diagram section.
A
B C
Fig. 9
Fig. 8
B
A
A
A
Controls and adjustments (Fig. 3 - 4)
A - Ringtone volume and mute control.
B - Brightness control.
C - Contrast control for 6329 and color for 6329/C, 6329/CD.
D - Lock release pushbutton
.
E - System self-start pushbutton
.
F - Pushbutton
for auxiliary service, 1st relay of 1st ac-
tuator type 69RH. When the pushbuttons
and
are pressed together, a second auxiliary service is acti-
vated, 2nd relay of 1st actuator type 69RH.
G - RESET pushbutton for monitor programming.
H - Ringtone mute LED. The fixed light illuminates when
the ringtone mute is enabled by means of slider “A” and
flashes when calls have been denied (red led).
I - Door open LED. On systems in which this function is used,
the LED remains lit permanently when the door/gate is
open (green led).
P1 + P2 (Toghether) =
P3
D
F
E
H
I
Fig. 3
P1
P2
P0
A
C
B
G
Fig. 4
A
B C
Fig. 9
Fig. 8
B
A
A
A
9
EN
6329, 6329/C, 6329/CD