Vimar ELVOX 41006, Installer Manual

Page: 17 / 60

EN
• Start-up after configuration: A, B, C (optional), D2. The device waits to be put into operating status (to be done with the
configuration software): on receiving the command, it goes into D3 status without restarting.
• Start-up in operating status: A, B, C (optional), D3.
Firmware Updating
Status LED L3 LED L2 LED L1
On ON ON ON
Updating – STEP 1 OFF OFF Blinking
3
Updating – STEP 2 OFF Blinking 3 Blinking 3
Updating – STEP 3 Blinking
3
Blinking
3
Blinking
3
3 Times: 0.25 s ON, 0.25 s OFF.
The firmware updating procedure of the electronic audio video module is performed in three steps, each of which is identified
by a specific aspect of the LEDs as indicated above. After updating, the device restarts automatically.
WEEE - User information
The crossed bin symbol on the appliance or on its packaging indicates that the product at the end of its life must be
collected separately from other waste. The user must therefore hand the equipment at the end of its life cycle over
to the appropriate municipal centres for the differentiated collection of electrical and electronic waste. As an alternative to
independent management, you can deliver the equipment you want to dispose of to the dealer when purchasing a new ap-
pliance of an equivalent type. You can also deliver electronic products to be disposed of that are smaller than 25 cm for free,
with no obligation to purchase, to electronics retailers with a sales area of at least 400 m
2
. Proper sorted waste collection for
subsequent recycling, processing and environmentally conscious disposal of the old equipment helps to prevent any possible
negative impact on the environment and human health while promoting the practice of reusing and/or recycling materials
used in manufacture.
Installation rules
Installation must be carried out in compliance with the current regulations regarding the installation of electrical equipment in
the country where the products are installed.
Regulatory compliance
EMC directive
Standards EN 61000-6-1,EN 61000-6-3, EN 60065 and EN 60118-4.
17
41006