Vimar ELVOX 41006, Installer Manual

Page: 16 / 60

EN
Indicators
The device has three LEDs dedicated specifically to the alerts and located at the top right, in addition to the four white LEDs,
already mentioned, located at the push buttons. Their appearance in the various situations of operation and use is described
below.
Icon LED Colour
L3 Green
L2 Green
L1 Red
L3
L1
L2
Local configuration
The white LEDs associated with the push buttons blink during local configuration tasks, with the timing described below
depending on the state of the device.
Status On - ON Off - OFF
Waiting for ordering push button modules 41010 0.50 s 1.00 s
The current value of the selected parameter (lock time, conversation time or
audio level) is not configurable via the push button interface (it was set using the
configuration software).
0.10 s 0.50 s
Standard operation
Status LED
Call in progress L3 blinking
Communication active L3 ON
Lock activated L2 ON
Missed communication (user busy or offline) L1 ON
Video message recording in progress L3 ON, L1 blinking
Device start-up
Status LED L3 LED L2 LED L1
A - Switch-on ON ON ON
B – Detection of secondary modules and/or waiting for or-
dering modules art. 41010
OFF OFF Blinking
1
C – Secondary module firmware updating in progress OFF Blinking 1 Blinking 1
D1 – Device awaiting configuration Blinking
1
Blinking
1
Blinking
1
D2 – Device configured but not operational Blinking
2
Blinking
2
Blinking
2
D3 – Device operational OFF OFF OFF
1
Times: 0.25 s ON, 0.75 s OFF.
2 Times: 1.00 s ON, 0.75 s OFF.
C status is only achieved when there are secondary modules to update. D1, D2 and D3 statuses are alternative to each
other: the first two are reached only during system installation and configuration. The three possible switch-on sequences
are described below:
• First start-up: A, B, C (optional), D1. The device awaits configuration (via the stated software) and when obtained it is
restarted, running the next sequence.
16
41006