7
Due Fili Plus telephone interface
• Type in
888 913
• Wait for the communication to be interrupted and hang up the phone.
5.4 Door opening control management method (888 99 1/0 6)
The interface can be set so that following a door opening control (key #) the entryphone and telephone
communication is automatically interrupted.
To enable or disable the automatic interruption mode, proceed as follows:
• Call the internal tap-off or the telephone number where the interface is connected on a telephone, wait for the
call tone and the subsequent three brief tones.
• Type in code
888
• Type in programming code
99.
• Type in
1
to activate automatic hang-up or
0
to return to standard mode
• Type in
6
• Wait for the three confirmation tones otherwise if you hear a brief tone and a long tone this means that
programming has not been accepted.
At the end of the operations, proceed directly to a new programming or hang up the telephone.
5.5 Number of rings before answering an incoming call from the telephone line (888
62 SQ)
Programming makes it possible to define the number of rings before the interface answers a telephone call. This
function is useful when the interface is connected directly to a telephone system in the absence of a telephone
switchboard, for instance during programming.
• Call the internal tap-off or the telephone number where the interface is connected on a telephone, wait for the
call tone and the subsequent three brief tones.
• Type in code
888
• Type in programming code
62
• Type in the number of rings
SQ
(
from 0 to 9
) you wish to configure
• Wait for the three confirmation tones otherwise if you hear a brief tone and a long tone this means that
programming has not been accepted.
At the end of the operations, proceed directly to a new programming or hang up the telephone.
5.6 Wait time before dialling a telephone number (888 85 T)
When the interface is connected to a telephone switchboard, it may be necessary to envisage a prolonged wait time
before you start dialling telephone numbers.
This programming makes it possible to define the wait time before you start dialling telephone numbers
(default 1).
• Call the internal tap-off or the telephone number where the interface is connected on a telephone, wait for the
call tone and the subsequent three brief tones.
• Type in code
888
• Type in programming code
85
• Type in the code corresponding to the pause seconds before you start dialling telephone numbers from
1
to
9
.
• Wait for the three confirmation tones otherwise if you hear a brief tone and a long tone this means that
programming has not been accepted.
At the end of the operations, proceed directly to a new programming using the new password or hang up the
telephone.
5.7 Manual or automatic answer (888 75 C 1/0)
By default, the interface is in manual answer mode, which means that both the Indoor Station and the interfaced
telephone ring simultaneously.
In automatic mode, after a short ring of the indoor station, the call is routed only to the Telephone.
N.B.: in this mode, the call tones towards the telephone will be heard at the entrance panel until it is answered.
N.B.: in the EXTENDED mode, all homes inherit the setting of the first call button C=1 and cannot be diversified.
To programme the
manual
or
automatic
answer, proceed as follows:
