12
Due Fili Plus telephone interface
Wait for the three confirmation tones otherwise if you hear a brief tone and a long tone this means that programming
has not been accepted.
At the end of the operations, proceed directly to a new programming or hang up the telephone.
5.14 Events (888 81 E M T PPP 1)
The
controls
can be managed automatically if and when certain events occur, such as ‘door open/closed’, ‘state of
an actuator’ and entryphone call.
To associate an event E with the control M or with a group S, proceed as follows:
• Call the internal tap-off or the telephone number of the indoor station where the interface is connected on a
telephone, wait for the call tone and the subsequent brief tones (three repeated brief tones)
• Type in code
888
• Ty
pe in programming code
81
• Ty
pe in the index of the event
E
from
0
to
9
• Type in the code of the control
M
from
10
to
49
you wish to associate.
• Type in the code of the type of event
T:
• Type in the address
PPP
of the module associated with the event:
T
Event
Type
PPP
0
Door closed
Outdoor Station
001 … 015
1
Door open
Outdoor Station
001 … 015
2
Change of door state
Outdoor Station
001 … 015
3
Relay open state
(only for appropriately configured 69PH)
Relay
001 … 016
4
Relay closed state
(only for appropriately configured 69PH)
Relay
001 … 016
5
Change of relay state
Relay
001 … 016
6
Lock control
Outdoor Station
001 … 015
7
ATTEMPTED call from outdoor station
Outdoor Station
001 … 015
8
Call from outdoor station
Outdoor Station
001 … 015
• Type in
1
• Wai
t for the three confirmation tones otherwise if you hear a brief tone and a long tone this means that
programming has not been accepted.
At the end of the operations, proceed directly to a new programming or hang up the telephone.
5.15 Delayed answer for entryphone calls (888 79 C T)
On arrival of an entryphone call, the interface may delay the answer, up to a maximum of 45 seconds, to give you the
chance to answer from the entryphones present in the system. When the delay is up, the interface hooks up to the
telephone line and transfers the entryphone call to the default number.
A different delay can be defined for each call button, between 0 and 45 seconds in 5-second
steps (default 0 s).
To associate the call button C with the delay time T, proceed as follows:
• Call the internal tap-off or the telephone number where the 40164 is connected on a telephone, wait for the call
tone and the subsequent brief tones (three repeated brief tones)
• Type in code
888
• Ty
pe in programming code
79.
• Ty
pe in the index referred to the call button
C
(
from 1 to 4
) you wish to configure.
• Typ
e in the delay time
T
from
0
to
9
(e.g. 1 = 5 s, 2= 10 s, etc.)
• Wai
t for the three confirmation tones otherwise if you hear a brief tone and a long tone this means that
programming has not been accepted.
At the end of the operations, proceed directly to a new programming or hang up the telephone.
