3/8 NT00000592-BATE-R-010-AN-191114
1.2 Safety instructions
Put on appropriate PPE (Personal Protective Equipment) before any work,
If work has to be carried out on the device, cut off the power supply on the main circuit breaker and make
sure that nobody can accidentally turn it back on,
Before operating the equipment, check the following points:
• Make sure that the device does not contain any foreign bodies,
• Check that all the components are mounted in their original positions,
• Check the earth connection,
• Check that the access hatch is properly closed,
1.3 Reception - Storage
In case of short shipment, non-conformity, and/or total or partial damage to the products delivered, the
Buyer must, in accordance with article 133-3 of the French Commercial Code, add written reservations to
the carrier’s delivery slip and confirm them within 72 hours by registered letter with acknowledgement of
receipt with a duplicate for the seller, If the equipment is received without express reservation, the Buyer
has no subsequent recourse against us,
The product must be stored protected from weather, shocks and soiling due to splashing of any kind during
its transport from the supplier to the final customer and on the site before installation,
1.4 Warranty
The equipment is covered by a 12-month warranty - Only parts - from the date of invoice,
The seller undertakes to replace all parts or equipment that we recognise as malfunctioning, to the exclu-
sion of any damages or penalties such as operating losses, market injury or other non-material or indirect
damage,
The following are excluded from our warranty: faults connected with abnormal use or use not in accord-
ance with the recommendations in our manuals and instructions, defects found following normal wear and
tear, incidents caused by negligence, failure to monitor or maintain correctly, defects due to poor installa-
tion of the equipment or to poor storage conditions before installation,
In any event, the seller is not responsible for equipment that has been modified or repaired even partially,
2.
RANGE / PRODUCT PRESENTATION
• Diameters from 125 to 500mm,
• Power from 600 to 18 000W
• Single-phase 230V 50Hz or three-phase 400V 50Hz power supply,
Standard construction
• Circular shell and Aluzinc treated steel IP44 connection box,
• Connection with class-C waterproof joints,
• IP44 cable grommet for cutting
• Sheathed 304 stainless steel heating elements,
• 1 automatic reset safety thermostat, set to 50°C,
• 1 manual reset safety thermostat, set to 100°C,
• 2 heating (red) / operating mode-fault (green) indicator LEDs
• 1 Triac-type electronic power regulator controlled by an external 0 - 10V signal,
•
1 air volume cut-out sensor, which shuts off the heating if the air speed is below 1,5m/s,