20
JETS 2
LIGHT
JETS 1
HEAT
JETS 2
JETS 1
LIGHT
MENU
SELECT
Preparation and Filling
Fill the spa to its correct operating level. (See SPA
MAINTENANCE section of this manual.) Be sure to open all
valves and jets in the plumbing system before filling to allow as
much air as possible to escape from the plumbing and the control
system during the filling process. After turning the power on at
the main power panel, the control panel display will go through
specific sequences. These sequences are normal and display a
variety of information regarding the configuration of the hot tub
control. After a few seconds, the spa will go into priming mode
and will display “PR”.
Priming the Pumps
As soon as the priming mode menu appears on the panel, press
the
“Jets 1” button once to start Pump 1 in low-speed and
then again to switch to high-speed. Next, if your spa is equipped
with a second pump press the Jets 2 or “Aux” button twice, to
turn it on high. The pumps will now be running in high-speed to
facilitate priming.
IMPORTANT:
A pump should not be allowed to run
without priming (water flowing out of the jets) for more than 2
minutes. Under NO circumstances should a pump be allowed to
run without priming beyond the end of the 4-5 minute priming
mode. Doing so may cause damage to the pump and cause the
system to energize the heater and go into an overheat condition.
NOTE:
Turning the power off and back on again will initiate a
new pump priming session. Sometimes momentarily turning the
pump off and on will help it to prime. Do not do this more than
5 times. If the pump(s) will not prime, shut off the power to the
spa and call for service.
Exiting Priming Mode
You can manually exit Priming Mode by pressing the
or
button. Note that if you do not manually exit the priming mode
as described above, the priming mode will automatically end
after 4-5 minutes. Be sure that the pump(s) have been primed by
this time. Once the system has exited Priming Mode, the control
panel will momentarily display the set temperature. The system
requires approximately 1-2 minutes of water flowing through the
heater to determine and display the correct water temperature.
Light Operation
By turning the light on and off, it will change the sequence of
colors from flashing, to fading, to solid color. Use the light button
COMFORT LINE SPAS
JETS 2
LIGHT
JETS 1
HEAT
JETS 2
JETS 1
LIGHT
MENU
SELECT
Jets 1
Press to toggle jets
LOW/HIGH/OFF
Jets 2
Press to toggle jets
LOW/HIGH/OFF (for
spas equipped with
dual pumps)
Lights Toggle
Press to toggle lights
ON/OFF
Down Button
Used to move through
menu selections
Up Button
Used to move through
menu selections
Menu/Select
Used to make
menu selections
2016 V&B Owners Manual.indd 20
3/3/2016 1:46:09 PM
