Villager VLN 9320, Instruction Manual

Page: 22 / 117

9
ADJUSTING THE LAMP POSITION
You can set the lamp to any position by
rotating the lamp head
.
To do this, undo fixing screws (7).
Then adjust the lamp to the required
position and retighten the fixing screw (7).
By rotating tubular frame (8), you can
attach the lamp to the desired surface
using the mounting bracket (10).
MAINTENANCE
MAINTENANCE
Cleaning and correct maintenance of the tool is important for both safety and for the
service life of the tool.
Note: Switch off the tool and disconnect it from the power supply (remove the battery/
unplug the power cord) before cleaning and maintenance - risk of electrical shock and
accidental starting.
•
Wipe the tool with a cloth moistened with water and a few drops of soap or
detergent. Brush clean hard to reach areas with a brush.
Note: Do not use cleaning agents that contain solvents or abrasive or corrosive
additives – risk of damaging tool surfaces.
•
Clear the tool vents and the accessory mount after each use of with brush and cloth.
•
Stubborn contamination in areas hard to access can be removed with compressed air.
• Always check after each use that any accessories are free from damage.
• Remove the accessory from the tool's drive after each use and clean the drive.
Warning:
•
Brake fluid, petrol, mineral oil and petroleum products must not come into contact with
the plastic parts of the power tool. This can damage or deform the plastic.
• Always wear safety goggles that seal against the face and also protect from the side
when using compressed air to blow clean the power tool. When performing very dusty
work, a dust mask should also be worn.