Villager Villager VCB 6E, Original Instruction Manual

Page: 16 / 95

Villager
VCB 6E (GB)
4
chassis has to be connected first. The other connection is to be made to the chassis,
remote from the battery and fuel line. The battery charger is then to be connected to
the supply mains; after charging, disconnect the battery charger from the supply
mains. Then remove the chassis connection and then the battery connection.
9. Remove all device cables from the battery before attempting to drive your vehicle
10. Use a power source with the voltage specified on the nameplate of the charger.
11. Check the input voltage (230V ~ 50Hz) and ensure that it corresponds to the mains
voltage, otherwise the charger may be damaged.
12. If an extension cable is used, the cable diameter must be sufficient for the power
required by the charger
13. Do not charge the battery packs in presence of flammable liquids or gases.
14. Never short circuit the device or connect the inlets and outlets of the device using
metal objects. Only use the supplied connecting cables to connect the device to a
battery.
15. Always make sure that the charger is disconnected from the mains when you connect
it and disconnect it to a battery.
16. Never place the device over or close to the battery to be charged. Gases from the
battery make the charger corrode and damage it. Set up the charger as far away from
the battery as the direct current cable allows.
17. Ensure that the device is always stored in a safe place. Do not expose the device to
rain or snow or other wet conditions. Avoid pouring or dripping water or other
liquids over it. If water penetrates electrical devices, the risk of electric shock
increases.
18. To protect against the risk of electrical shock, do not immerse the unit, cord or plug in
water or other liquid.
19. Ensure that all plugs and cables are free of moisture. Never connect the device to the
mains with wet or moist hands.
20. Never carry charger by cord or yank it to disconnect from receptacle.