Villager VGS 260 PRIME, Manual

Page: 46 / 172

Villager VGS 260 PRIME (GB)
23
When restarting immediately after stopping the engine. Choke knob in the first-stage
position (choke open and throttle lever in the starting position).
Once the choke knob has been pulled out, it will not
return to the operating position even if you press
down on it with your finger. When you wish to
return the choke knob to the operating position,
pull out the throttle lever instead.
5. While holding the saw unit securely on the
ground, pull the starter rope vigorously. (OP6)
6. When firing occur, push in the choke knob
and pull the starter again to start the engine.
7. Allow the engine to warm up with the
throttle lever pulled slightly.
Before you start the engine, make sure the saw
chain is not contacting anything.

CHECKING OIL SUPPLY
After starting the engine, run the chain at medium speed and see if chain oil is scattered
off as shown in the figure. (OP7)
WARNING
NOTE
NOTE