Villager VGI 2400, Manual, Page: 47 / 297

15
Villager VGI 2400 (GB)
OPERATION
Grounding the Generator
To avoid electrocution, this generator must be properly grounded prior to use. For
instructions see Control Panel Functions on earlier pages.
How to Start Engine
•
Place generator on a level surface. All electrical loads MUST be disconnected
from generator.
•
Turn the Economy switch to "OFF".
•
Turn the fuel cap Air Vent to the "ON" position.
•
Turn the 3 in 1 Start Switch to "CHOKE".
•
Pull recoil handle (starter cord) slowly until resistance is felt, then pull rapidly.
•
Let engine run for several seconds and then gradually, as engine warms up,
turn the 3 in 1 Start Switch to the “RUN” position .
Pull cord recoils rapidly and pulls arm towards engine faster
than you can let go which could result in injury.
•
To avoid recoil, pull starter cord slowly until resistance is felt, then pull rapidly.
Note: To start the generator with the Economy switch in the “ON” position:
•
Disconnect all electrical loads from generator.
•
If ambient temperature is below 32°F (0°C) allow about 3 minutes for the
engine to warm up.
•
The Economy is in “ON” position, the unit returns to normal operation after the
above warm up time.
•
Economy switch must be turned to the “OFF” position when using electronic
devices that require a large starting current, such as a compressor.