Villager ATLAS 3010 T, Original Instruction Manual

Page: 28 / 141

Villager ATLAS 3010 T (GB)
11
this case, intervene promptly by touching up the paintwork using a rustproof paint to prevent the formation
of rust that would lead to corrosion of the metal.
Remove the transmission casing by removing the screws and clean around the transmission and drive belts
with a brush or compressed air once or twice a year.
Once every season, the drive wheels should be cleaned internally. Remove both wheels. Clean the gear
wheel and the wheel gear rim of grass and dirt using a brush or compressed air.
CHANGING BLADES
To replace the blade, undo the screw.
Empty the oil tank before removing the blade
Reinstall as illustrated. Tighten the screw properly. Tightening torque 45 Nm.
When replacing the blade, the blade screw should also be replaced.
CHANGE OIL
1. Let engine runs out of out, and wait until engine stopped and
cooled slightly.
2. Disconnect spark plug wire and keep away from spark plug.
3. When engine is still warm, remove oil drain plug (A). Drain oil into a proper container.
4. Clean the oil drain plug before restoring it back.
5. Place engine level. Remove dipstick. Add new recommended oil about 0.3L slowly to upper limit on
dipstick, don’t overfill.
6. Replace dipstick
WARNING: Prevent skin contact with
used engine oil. Wash your skin with
soap and water after oil change
CAUTION: Used oil is a hazardous
waste product. It is suggested to
bring used oil to your local recycling
center with properly sealed container
a sealed container to your local
recycling center. Do not discard with
household waste.