Villager ATLAS 3010 T, Original Instruction Manual

Page: 27 / 141

Villager ATLAS 3010 T (GB)
10
STOP ENGINE

To stop engine, release operator presence control bar.
WARNING! The blade will continue to rotate for a few seconds after the engine has stopped. Disconnect
the spark plug cap if the lawnmower is to be left unattended.
MOWING TIPS

Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to reduce
pushing effort and to keep from overloading the engine and leaving clumps of grass clippings. It may
also be necessary to reduce ground speed and/or run the lawn mower over the area a second time.

For extremely heavy cutting, reduce the width of cut by over lapping previously cut path and mow
slowly.

Pores in cloth grass catchers can become filled with dirt and dust with use and catchers will collect less
grass. To prevent this, regularly hose catcher off with water and let dry before using.

Keep top of engine around starter clear and clean of grass clippings and chaff. This will help engine air
flow and extend engine life.
MAINTENANCE
IMPORTANT - Regular, careful maintenance is essential for keeping the safety level and original
performance of the machine unchanged in time.
1)Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
Regular maintenance is essential for safety and performance.
2)Never store the equipment with fuel in the tank inside a building where vapour may reach a flame or a
spark or a source of extreme heat.
3)Allow the engine to cool before storing in an enclosed space.
4)To reduce the fire hazard, keep the engine, exhaust silencer, battery compartment and fuel storage area
free of grass, leaves, or excessive grease. Do not leave containers with grass cuttings in rooms.
5)For reasons of safety, do not use the equipment with worn or damaged parts. Parts are to be replaced and
not repaired. Use genuine spare parts (blades should always bear the symbol).
Parts that are not of the same quality can damage the equipment and be dangerous for your safety.
6)If the fuel tank has to be drained , this should be done outdoors and when the engine is cool.
7)Wear strong work gloves when removing and reassembling the blade.
8)Check the blade’s balance after sharpening.
9)Check the self-closing guard and grass-catcher frequently for wear and deterioration.
10)Whenever the machine is to be handled, transported or tilted you must:
-Wear strong working gloves;
-Grasp the machine at the points that offer a safe grip, taking account of the weight and its distribution.
CLEANING
Carefully clean the machines with water after each cut; remove the grass debris and mud accumulated inside
the chassis to avoid their drying and thus making the next start-up difficult.
The paintwork on the inside of the chassis may peel off in time due to the abrasive action of the cut grass; in