Viking VGR30, Service Manual

Page: 27 / 40

27
INDICATOR LIGHT REMOVAL
1. Shut off power to the unit.
2. Remove the control panel. (See control panel
removal.)
3. Disconnect the wiring from the indicator light.
4. Push the indicator light out of the control panel.
BAKE/BROIL THERMOSTAT REMOVAL
1. Shut off power to the unit.
2. Remove the control panel. (See control panel
removal.)
3. Remove the two (2) clips securing the thermostat
bulb to the inner back wall.
4. Remove the left side grates, burner bowls and
grate
supports.
5. Carefully pull the capillary tube out of the oven
cavity.
6. Disconnect the thermostat wiring one lead at a
time and connect to the appropriate terminal on the
replacement thermostat.
7. Remove two (2) screws mounting thermostat to
the control panel.
OVEN IGNITOR REMOVAL
1. Shut off power to the oven.
2. Remove oven door. (See oven door removal.)
3. Remove the lower access panel below the oven
door by removing two (2) mounting screws on
either side under the oven door hinges.
4. Disconnect the wire leads to the ignitor.
5. Remove the oven burner. (See oven burner
removal.)
6. Remove two (2) screws securing the ignitor to the
burner and remove the ignitor.
BROIL GAS VALVE REMOVAL
1. Shut off power to the oven.
2. Shut off gas supply to the oven.
3. Remove right side grates, burner bowls and grate
supports.
4. Disconnect the wire leads to the broil valve
connecting leads to replacement valve.
5. Disconnect the gas supply tubing from the gas
valve.
6. Remove two (2) screws securing the gas valve to
the mounting bracket.
NOTE:
CHECK ALL CONNECTIONS FOR LEAKS
USING A SOAP SOLUTION AFTER INSTALLING
THE REPLACEMENT VALVE.
OVEN GAS VALVE REMOVAL
1. Shut off power to the oven.
2. Shut off gas supply to the oven.
3. Remove the oven door. (See oven door removal.)
4. Remove the lower access panel below the oven
door by removing two (2) mounting screws on
either side under the door hinges.
5. Disconnect the wires leads to the gas valve.
6. Disconnect the gas supply tubing to the gas valve.
7. Remove two (2) screws securing the gas valve to
the mounting bracket.
NOTE: CHECK ALL CONNECTIONS FOR LEAKS
USING A SOAP SOLUTION AFTER INSTALLING
THE REPLACEMENT VALVE.