19
OPTION 1
If a solid soffit is 1” (2.5 cm) or less above the wine cellar, anti-tip boards are not required. To
secure the wine cellar raise unit until compartment is firmly seated under the soffit.
OPTION 2
If a solid soffit is not available or soffit is more than 1” (2.5 cm) above wine cellar, center wood
boards on rear wall 1/4” (0.6 cm) maximum above wine cellar. Attach wood boards to wall studs
with six of the provided wood screws, making sure that screws are engaged in wall studs 1-1/2”
(3.8 cm) minimum and that boards extend 2” (5.0 cm) minimum over the top rear of wine cellar
compressor cover. To secure the wine cellar, raise unit until compartment is firmly seated under
the anti-tip board.
OPTION 3
Position the wood block over the unit and secure it to wall studs using eight of the provided
wood screws and “L” brackets. Make sure screws extend a minimum of 1” (2.5 cm) into each of
the two wall studs. The wood block must extend a minimum of 3” (7.6 cm) over the unit. To
secure the wine cellar, raise unit until compartment is firmly seated under the anti-tip boards.
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power at breaker or turn power
disconnect switch to OFF position before
performing any installation procedure. Failure
to do so can result in death or electrical shock.
Solid Soffit
1”
(2.5 cm)
or less
Rear
Wall
OPTION 1
1/4” (0.6 cm)
maximum
2”
(5.0 cm)
minimum
Two 2” x 4”
(3.8 cm x 3.9 cm)
boards
attached to
wall with six
wood screws
(minimum)
OPTION 2
1/4” (0.6 cm)
maximum
3”
(7.6 cm)
minimum
“L” bracket
with (4) screws
on each end.
(1) 2”x4”
(3.8 cm x 3.9 cm)
attached to
both “L”
brackets -
minimum of
1” (2.5 cm) screws.
Screws extend
minimum of
1” (2.5 cm) into
each wall stud.
OPTION 3
Securing Your Wine Cellar
(3 options)
