8
4.2 CLEANING
Clean the lifejacket in mild soapy water only.
4.3 PACKING (See page 42)
Packing of lifejacket with Halkey Roberts
®
automatic or manual inflator
1. Place the lifejacket on a table. Slide the
neoprene cover over the CO2 bottle and
attach the elastic band. Attach the LIFT
webbing on the hook/loop material of the
buoyancy chamber.
2. A+B Start closing the zipper. Fold the inner
part of the buoyancy chamber towards the
middle and fold the outer part on top.
3. A+B Zip the left part of the cover. Fold
the top of the buoyancy chamber as fan.
The welding seam must be at the top. Close
the zipper at the neck.
4. A+B Fold the inner part towards the middle.
Fold the outer part on to, so the inflator is
on top of the buoyancy.
5. If inflator is Halkey Automatic, the
release handle must protrude from the
bottom of the cover. Close cover.
6. A+B If inflator is Halkey Manual, the release
handle must protrude from the side of the
cover - through the button hole next to the
zipper. Close cover.
4.4 REPLACEMENT OF THE CO2-CYLINDER AND
BOBBIN - HALKEY ROBERTS
®
Automatic inflator
After use in freshwater dry the lifejacket. If the
lifejacket has been used in saltwater, it must be
rinsed with freshwater and then dried. Remove
any air in the lifejacket using the oral inflation
valve.
DISASSEMBLY (Figures 2 og 3 on pages 40-41)
Step 1:
Unpack or open the lifejacket so that the
automatic inflator is visible. Remove the
protective neoprene cover. Slide the cylinder
holder and O-ring (figure 2) down so it is not
holding on to the manifold nut. Unscrew the
cylinder from the inflator.
Step 2:
Remove gas CO2 cylinder by rotating cylinder
counter-clockwise and removing the cylinder
from holder and O-ring. Discard cylinder.
Step 3:
Remove cap by turning counter-clockwise.
Step 4:
Remove the bobbin from the cap or housing
unit. Discard bobbin (yellow). Check the housing
to be sure it is clear and dry.
Note: The bobbin (yellow) body may remain
in the housing or in the cap assembly when
you remove the cap. The bobbin body must be
removed before rearming.
REARMING
Note: Rearming must follow the sequence
below.
Step 5:
A new bobbin must be used. New bobbin must
have been purchased within four (4) years. If the
bobbin purchase date is unknown, check the
date on the bobbin and replace it if it is more
than four (4) years old.
Step 6:
IMPORTANT!
Bobbin (yellow) must be installed into the
housing (Figure 3), white side up, aligning the
slots on the bobbin with the ridges inside the
threaded housing. The bobbin will slide in easily
if installed correctly.
EN
VIKING RESCYOU
™
VISTA (PV9220) LIFEJACKET
Summary of Contents for PV9220
Page 40: ...40 Fig 2...
Page 43: ...43...
