®
© 2009 Viking Preferred Service
24
Bake and Broil Solenoids
The bake and broil solenoids provide a means to
open the gas valve. When the DSI module receives
120 VAC input, the voltage is stepped down to 8 to
18 VDC and output to the appropriate bake or broil
solenoid. This voltage is sufficient to open the gas
valve and allow gas to flow to the burner.
NOTE:
The solenoids are sized for special voltage
and current. DO NOT use voltage above 8 to 18
VDC to operate the solenoids.
To access the bake and broil solenoids, remove the
unit form installation and remove the rear cover.
The bake and broil solenoids are located on the
right hand side when viewed from the rear. The
lower solenoid is for bake and the upper solenoid is
for broil.
Test Procedures –
Bake and Broil Solenoids
1.
Remove power to the unit.
2.
Set the Volt-Ohm meter to read resistance.
3.
Measure resistance at bake solenoid terminals.
4.
The Volt-Ohm meter should read 215 ohms
+/- 30 ohms.
Service Diagnostics and Procedures
Broil Solenoid
Bake Solenoid
Test Points
Test Points
