INSTALLATION AND SET-UP INSTRUCTIONS
SURFACE AND PAD REQUIREMENTS
• Your new portable spa must be placed on a uniformly firm,
flat and level surface. A concrete pad 4 inches thick is
best.
• In order to prevent flooding of the electrical equipment, the
pad must be such that water will drain away from the spa.
• If your spa is located near sprinklers, adjust or cap them so
as not to hit the siding of the spa.
BALCONIES AND DECK REQUIREMENTS
• Decking must be constructed to support 85 pounds per
square ft.
• Balconies must be constructed to meet current state and
local codes.
• Gates must be self-closing and self-latching.
ELECTRICAL REQUIREMENTS (All Models)
• Your 120-volt spa pack comes installed with a 15-amp rated
dedicated G.F.C.I. cord connected device.
• Your 120-volt spa pack is designed to be “PERMANENTLY
CONNECTED”.
• Use of any extension cord is dangerous and is not to be used in
conjunction with the operation of the spa. Low voltage damage
may result and will void your warranty.
•
It is the customer’s responsibility to acquire necessary
permits and to arrange for installation and hook up of
the electrical power.
•
Your spa comes set up from the factory to accept 120v
ONLY. Any attempt to remove the factory installed GFCI
cord or alter the voltage will result in voiding your
warranty.
5
Summary of Contents for Plug-n-Play Spas Series
Page 1: ...Owner s Manual V 1 0 0 V 3 0 0 V 5 0 0 2014...
Page 23: ...NOTES 22...
