V300/V500 FEATURES
The V300/V500 model features a Waterfall jet, which allows the user
to regulate the flow of water to the jet by simply turning the valve for
the waterfall from “off” to “on”. (See illustration below)
9
Regulates Air
into Jets
Waterfall
On/Off Control
V300 in Gray
*
To drain the spa, make sure the gate valve is in the Up /
Open position. Remove the cap from the drain and attach
the garden hose. Open the valve by turning the large part of
the drain counterclockwise until it stops. Pull on the drain that
the hose is connected to until you hear it “pop”. Water will
gravity drain through the garden hose. Be sure to close the
drain prior to refilling. Note: the drain will not remove all of
the water in the spa. You may have to remove a small amount
of water by hand.
Water Gate Valve
Drain* for V100
To drain your spa, power must be disconnected at the cir-
cuit breaker. Locate the drain faucet on the corner near the
bottom of the side panel next to the equipment. 1. Twist
cap off and attach a garden hose to the opening. 2. Turn
the outside body counter clockwise until it stops. 3. Pull on
the drain that the hose is connected to until you hear a
“pop”. 4. Drain the spa. 5. Reverse this procedure to shut
the water off. Note: the drain will not remove all of the
water in the spa. You may have to remove a small amount
of water by hand.
Drain* for V300/V500
Summary of Contents for Plug-n-Play Spas Series
Page 1: ...Owner s Manual V 1 0 0 V 3 0 0 V 5 0 0 2014...
Page 23: ...NOTES 22...