16
Operation
17
Lighting Burners
All burners are ignited by electric ignition. There
are no open-flame, “standing” pilots.
Surface Burners-Automatic Reignition
To light the surface burners, push and turn the
appropriate control knob counter clockwise to any
position. This control is both a gas valve and an electric switch. Burners
will ignite at any “ON” position with the automatic re-ignition system. If
the flame goes out for any reason, the burners will automatically reignite
if the gas is still flowing. When gas is permitted to flow to the burners,
the electric igniters start sparking. On all surface igniters you should hear
a “clicking” sound. If you do not, turn off the control and check that the
unit is plugged in and that the fuse or circuit breaker is not blown or
tripped.
Within a few moments, enough gas will have traveled to the burner to
light. When the burner lights, turn the burner control to any position to
adjust the flame size. Setting the proper flame height for the desired
cooking process and selecting the correct cooking vessel will result in
superior cooking performance, while also saving time and energy.
Surface Cooking Tips
Your range is equipped with a variety of different sized surface burners.
Below is a guide for which burners work best for certain cooking
applications.
Operation
Surface Operation
Surface Cooking Tips
(cont.)
• Use low or medium flame heights when cooking in vessels that are
poor conductors of heat, such as glass, ceramic, and cast-iron.
Reduce the flame height until it covers approximately 1/3 of the
cooking vessel diameter. This will ensure more even heating within
the cooking vessel and reduce the likelihood of burning or scorching
the food.
• Reduce the flame if it is extending beyond the bottom of the
cooking vessel. A flame that extends along the sides of the vessel is
potentially dangerous, heats the utensil handle and kitchen instead
of the food, and wastes energy.
• Reduce the flame height to the minimum level necessary to perform
the desired cooking process. Remember that food cooks just as
quickly at a gentle boil as it does at a rolling boil. Maintaining a
higher boil than is necessary wastes energy, cooks away moisture,
and causes a loss in food flavor and nutrient level.
• The minimum pot or pan (vessel) diameter recommended is 6”
(15 cm). Use of pots or pans as small as 4” (10 cm) is possible but
not recommended.
Surface Heat Settings*
*Note:
The above information is given as a guide only. You may need
to vary the heat settings to suit your personal requirements.
Heat Setting
Use
Simmer
Melting small quantities
Steaming rice
Simmering sauces
Low
Melting large quantities
Med Low
Low-temperature frying (eggs, etc.)
Simmering large quantities
Heating milk, cream sauces, gravies,
and puddings
Med
Sauteing and browning, braising, and
pan-frying
Maintaining slow boil on large quantities
Med High
High-temperature frying
Pan broiling
Maintaining fast boil on large quantities
High
Boiling water quickly
Deep-fat frying in large utensil
Surface Operation
Burner
Use
Front left dual stacked
18,000 BTU burner
A versatile burner which is good for both
bringing large quantities of liquid to
temperature or for simmering larger amounts
of sauces, etc.
Rear left 8,000 BTU burner
Best for simmering delicate sauces, etc.
Center 9,000 BTU burner
Best for use with the reversible griddle/grill
accessory
Front right 17,000 BTU burner Best for bringing large quantities of liquid to
temperature and when preparing large
quantities of food
Rear Right 12,000 BTU burner Best used for most standard surface cooking
needs
