10
Programming Features
Index
DESCRIPTION
Section
Page
Ext Relay Activation Time (0.5 - 99 seconds, factory set to 5 seconds)
22
16
Ext Relay Buzz Volume (1 - 3 or Disabled, factory set to 3)
23
16
Ext Relay Latch Commands
(Enabled or Disabled, factory set to Enabled)
NOTE:
Relay Mode must be set to Door Strike
24
16
Panic Button mode (Enabled or Disabled, factory set to Disabled)
25
16
Speaker Mode (ON, OFF / Silent Monitor, or OFF until Answered, factory set to ON)
26
16
SIP Paging Volume (0 - 1 9, factory set to 1)
27
16
Ring Volume (0 - 19, factory set to 5)
28
17
Microphone Volume (0 - 9, 0 = Auto, factory set to 5)
29
17
Talk/Listen Delay (VOX) (0.1 - 0.9 seconds, factory set to 0.5 seconds)
30
17
In-Band Audio Call Progress (Enabled or Disabled, factory set to Enabled)
31
17
In-Band Audio Detect Sensitivity
(1 - 9, 1 = minimum, 9 = maximum, factory set to 5, power cycle unit after setting)
32
17
Redial Count (1 - 9 or Disabled, factory set to Disabled)
33
17
SIP Page / Call Length Time Out (Disabled or 1 - 9 minutes, factory set to 3 minutes)
34
17
Inbound Call Mode
(Disabled, Auto Answer, Auto Answer-Secure, Ring, or Ring with AGC, factory set to Auto Answer)
35
18
Ring Cadence (factory set to Normal Ring = 2 seconds ON, 4 seconds OFF)
36
18
Redial on Ring No Answer (Disabled or 1-9 rings, factory set to 7)
37
18
Redial on Busy (Disabled or Enabled, factory set to Enabled)
38
18
Mute Current / Next Alarm
39
19
Permanent Alarm Mute
40
19
Programming Username and Password
41
19
IP Firmware
42
19
Unit Firmware
43
20
Import / Export
44
20
Clear Speaker Settings
45
20
Clear IP Settings
46
20
Diagnostics (used to check microphone, speaker, and external relay operation)
47
20
3. Peer to Peer Settings
2. SIP Server
When set to Peer to Peer mode, a SIP server is not used. The unit should be programmed with a static IP address and
username, a password is not used. Caller ID can be programmed if needed. Simply call the unit by entering the
programmed “[email protected]...(static IP address for the unit)”. The static IP address is normally programmed into
a page button on the VoIP telephones.
NOTE:
Peer to Peer mode does not affect multicast paging.
1. Unit Name
Up to a 30 character unit name can be assigned to the
300TB-IP
being programmed.
Programming Features
Enter the IP address or URL of your SIP server or service provider in this field. The SIP server IP address is limited to
74 characters.
Note:
If an alternate SIP server IP address is programmed, the IP address for the SIP server and
alternate SIP server will be limited to 31 characters.
Note:
If outbound proxy is not required, enter the SIP server IP
address into the Outbnd Proxy field.
