10
Programming Features
Index
DESCRIPTION
Section
Page
SIP Paging Volume (0 - 1 9, factory set to 1)
22
16
Ring Volume (0 - 19, factory set to 5)
23
16
SIP Page Length Time Out (Disabled or 1 - 9 minutes, factory set to 3 minutes)
24
16
Multicast Page Length Time Out (1 - 255 seconds, factory set to 180 seconds)
25
16
Inbound Call Mode
(Disabled, Auto Answer, Auto Answer-Secure, Ring, factory set to Auto Answer)
26
16
Ring Cadence (factory set to Normal Ring = 2 seconds ON, 4 seconds OFF)
27
17
Mute Current / Next Alarm
28
17
Permanent Alarm Mute
29
17
Programming Username and Password
30
17
IP Firmware
31
18
Unit Firmware
32
18
Import / Export
33
18
Clear Speaker Settings
34
18
Clear IP Settings
35
18
Diagnostics (used to check External relay operation)
36
18
3. Peer to Peer Settings
2. SIP Server
When set to Peer to Peer mode, a SIP server is not used. The unit should be programmed with a static IP address and
username, a password is not used. Caller ID can be programmed if needed. Simply call the unit by entering the
programmed “[email protected]...(static IP address for the unit)”. The static IP address is normally programmed into
a page button on the VoIP telephones.
NOTE:
Peer to Peer mode does not affect multicast paging.
1. Unit Name
Up to a 30 character unit name can be assigned to the
300-IP
being programmed.
Programming Features
Enter the IP address or URL of your SIP server or service provider in this field. The SIP server IP address is limited to
74 characters.
Note:
If an alternate SIP server IP address is programmed, the IP address for the SIP server and
alternate SIP server will be limited to 31 characters.
Note:
If outbound proxy is not required, enter the SIP server IP
address into the Outbnd Proxy field.
4. Outbound Proxy
If your SIP provider requires an outbound proxy IP address enter it in the “Outbnd Proxy” field. If outbound proxy is not
required enter the SIP sever IP address into the “Outbnd Proxy” field.
NOTE:
If not required, this field must match your
SIP server IP address.
5. Authentication ID
If your SIP provider requires Authentication ID, enter it in the “Authentic. ID” field.
If Authentication ID is not required,
leave this field blank.
6. Register Fails (Re-Resolve or Alternate Server)
When registered to a SIP server in the event that registration is lost you can program the unit to re-resolve using the
current SIP server IP address or route pages through an alternate SIP server. With Alternate Server selected enter the
IP address of the alternate SIP server in the field next to the Register Fails drop down box.
Note:
With an alternate
SIP server IP address programmed, the IP address for the SIP server and alternate SIP server will be limited to 31
characters.
