Document: LT0439 Vigilant
MX1-Au
Operator Manual
Issue 1.73
23 October 2018
Page 11-1
This chapter contains instructions for installing the
MX1
and wiring it to
MX
Loop devices, alarm devices, and ancillary equipment.
Further wiring and gear plate drawings are included in the
MX1
Wiring
Diagrams Manual (LT0442) included with each
MX1
panel.
Topic
See Page
Wiring must comply with AS/ACIF S009 and be installed
by an ACMA-registered installer.
Remove power to the MX1 panel before plugging in or
disconnecting modules such as 16 Zone LED Displays,
LCD/Keyboard, MX Loop Cards, etc.
MX1
is available in 8U and 15U cabinets that simplify installation by
provision of:
appropriate mounting holes and mounting template
space for cabling, including knockouts in the cabinet for top/bottom
cable entry and slots in the gearplate for entry from behind the
cabinet
Chapter 11
Mounting and Wiring Instructions
Introduction
In this Chapter
Cabinet Installation