Document: LT0439 Vigilant
MX1-Au
Operator Manual
Issue 1.73
23 October 2018
Page 11-23
The
MX1
cabinet has provision for 32 zones of LED displays using two
MX1
16 zone display modules (FP1002). No displays are included as
standard. In the 15U cabinet additional zone LEDs can be provided by
the 4U 80 zone module (ME0457), multiple
MX1
16 zone display
modules (FP1002), and additional 26 way FRCs.
Figure 11-19 shows the wiring for one zone display board.
The FP1002 kit comes with 1 x LM0339 for connection to the
LCD/keyboard (when needed) and 1 x LM0291 for connection to an
adjacent zone LED Display board.
PA1057 LCD/
Keyboard PCB
LM0339
PA1020 Zone
Display Board 1
Zones 1-16
T
O
N
E
X
T
J2
F
R
O
M
P
R
E
V
IO
U
S
Figure 11-19 – Single Zone Display on front panel (rear view)
A second zone display board (part number FP1002) can be fitted, as
shown in Figure 11-20. The display board with the lowest zone numbers
is cabled furthest from the
MX1
LCD/Keyboard.
Note that the LM0339 FRC loom from the LCD/keyboard must be moved
from the first display board to the second display board, and the second
display board connected to the first display board with the LM0291 FRC
loom provided with the zone display kit.
With additional display boards the LCD/Keyboard is wired to the board
with the highest numbered zones through to the last board showing
(nominally) zones 1-16, following the From Previous - To Next pattern.
Drawing 1982-88 shows representative arrangements of positioning and
cabling.
Zone LED
Displays
