TS21I_ELE_O2 User Manual
Page
7
of
14
Jumpers to set NO/NC contacts for relays
There are three jumpers shown
JP1
used to set
Relay1
,
JP2
used to set
Relay2
and
JP3
used to
set
Relay3
. Using these jumpers, user can set
NO
type contact or
NC
type of contact.
For
Relay1
→
JP1
,
Jumper between pin 1 and 2, Relay1 will be
NO
type
Jumper between pin 2 and 3, Relay1 will be
NC
type
JP1
For
Relay2
→
JP2
,
Jumper between pin 1 and 2, Relay2 output will be
NO
type
Jumper between pin 2 and 3, Relay2 output will be
NC
type
JP2
For
Relay3
→
JP3
,
Jumper between pin 1 and 2, Relay3 will be
NO
type
Jumper between pin 2 and 3, Relay3 will be
NC
type
JP3
Modbus Settings:
The following connection diagram shows
TS21I_ELE_O2 units connected with Gas Detection Panel.
Siren and power connector locations are shown as below.
Addresable
Gas Detection Panel (AGDS-32) connection Diagram with TS21I_ELE_O2
units
To communicate TS21I_ELE_O2 unit with gas detection panel, user must set proper slave address
using configuration menus. Maximum of 255 slave IDs can be set.
1
2
3
1
2
3
1
2
3
