Vighnaharta TrueSafe TS21I ELE O2, User Manual

Page: 12 / 14

TS21I_ELE_O2 User Manual
Page 12 of 14
Function names in the menu Process Steps
5. o2ZC
(Output 2 Zero calibration)
This is a calibration function used
to calibrate voltage output for
0V.
o2SC
(Output 2 Span calibration) This
is a calibration function used to
calibrate voltage output for 5 /
10V depending on voltage range
set in menu
A oP .
1. Go to menu A oP .
2. Press Up or Down key to select 0 – 5v or 0 -10v
range.
3. Go to menu o2ZC .
4. Measure voltage between A-O/P and GND
connections on CON2.
5. Press Up or Down key to increase or decrease the
count to get 0V output across A-O/P and GND.
6. Press ENTER key to save the count.
7. Go to menu o2SC .
8. Measure voltage between A-O/P and GND
connections on CON2.
9. Press Up or Down key to increase or decrease the
count to get 5v or 10v output across A-O/P and
GND.
10. Press ENTER key to save the count.
11. Press ESCAPE key to exit from Configuration mode
and remain in Idle or Scan mode.
6. bAUd
User can set baud rate either 2400,9600,19200.
1. Press ENTER to go in main menu.
2. Use Down key to select ‘ bAUd ’ function.
3. To go into ‘ bAUd ’ function, again press ENTER key.
4. Use Up or Down keys to select any one baud rate
from following option 2.4(2400), 9.6(9600),
19.2(19200).
5. Press Enter key to save the settings or press
Escape key to return to previous menu without
saving the settings.
7. PArt
User can set Parity either None, Even, Odd.
1. Press ENTER to go in main menu.
2. Use Down key to select ‘ PArt ’ function.
3. To go into ‘ PArt ’ function, again press ENTER key.
4. Use Up or Down keys to select any parity from
following option ‘ nonE ’ (None), ‘ EuEn ’ (Even),
‘_ odd ’ (Odd).
5. Press Enter key to save the settings or press
Escape key to return to previous menu without
saving the settings.
8. Addr
User can set device address from 0 to 254.
1. Press ENTER to go in main menu.
2. Use Down key to select ‘ Addr ’ function.
3. To go into ‘ Addr ’ function, again press ENTER key.
4. Use Up or Down keys to select address from 0 to
255.
5. Press Enter key to save the settings or press
Escape key to return to previous menu without
saving the settings.