TIHD 932-4
IGNIS - Conventional 4 wire Heat Detector
Humidity
95% non-condensing
Mechanical specifications
Protection
class
NA
Cabinet
material
ABS Thermoplastic
Cable entry
NA
Dimensions
100 x 36 (diameter x height)
Mounting
Ceiling mount
Weight
110 g
Output
PFC output (Normally open or Normally
closed dry contact)
Accessories
with Unit
2 Screws (25*8 mm)
Ravel Plug (25 mm)
User Manual
Warranty
We warranty its enclosed detector to be free from defects in
materials and workmanship under normal use and product
warranty of 12 months from the date of supply.
No agent, representative, dealer, or employee of the
company has the authority to increase or alter the
obligations or limitations of this warranty.
Warning/Caution
●
Install and use equipment in accordance with
installation instructions manual.
●
Do not Paint the Detector.
●
Dust cover must be removed before
commissioning to avoid detector contamination.
●
During maintenance, do not remove the detector
before notifying proper authority.
Maintenance
Before cleaning, disable the system to prevent false alarms
and inform proper authority.
1.
Remove the detector to be cleaned from the
system.
2.
Gently remove the back plate and PCB from the
sensor chamber.
3.
Use a blower to clean the sensor.
4.
Re-insert the PCB & back plate properly.
5.
Fit the detector head with the base of the detector.
NOTE: Strictly maintenance to be done by a technically
trained person.
Installation Procedure:
Note: Before Installation, this manual should be available with
the user of this equipment.
1.
IGNIS detectors are intended for mounting on a
ceiling or a wall in accordance with requirements.
2.
Fit the mounting base to the electrical junction box
with the given screws. If a high profile base is used,
then a junction box is not required. (High profile base
directly comes up as a built-in junction box.)
3.
Connect ZONE ‘+’ & ‘- ‘to the mounting base pin 1 and
3 respectively (Refer connection diag.)
4.
Align detector head notch with mounting base notch
as shown in fig.
5.
Push the detector head into the base and turn
clockwise to secure it in place.
