ViewSonic NMP-500
8 of 38
By default, the video output is set to S-Video. But, you can choose one of the following
connections if you prefer:
S-Video
:
Default. Connect an S-Video cable from the S-Video interface on the
back of the
NMP-500
to the S-Video interface on the back of the display.
DVI
Connect a DVI cable from the back of the
NMP-500
to the DVI interface
on the back of the display.
VGA
:
Using the DVI-VGA adapter included, connect a VGA cable from the VGA
interface on the back of the
NMP-500
to the VGA interface on the back of the
display (PDP or LCD).
Note
: do not use both a VGA connection and a YPbPr
connection at the same time.
Component
:
Using the S-Video/YPbPr adapter.
Composite
:
Using an RCA cable.
Click the
Show IP
button shown below. The
IP address
appears on-screen momentarily
then disappears after about four seconds. If the
IP address
does not appear, check that
the
NMP-500
and the display are set to the same video output settings: i.e., S-Video to
S-Video, or VGA to VGA, etc. To change the output setting, login to the
NMP-500
(Step 3)
and select
Management
>
Video/Audio
for the screen shown below.
For more
information, see the Video/Audio Configuration section later in this guide.
Show IP
Summary of Contents for NMP-500
