40
2) Please check the antennas installation of the air and ground units is normal: whether
the antennas is blocked; whether the antennas connection is loose; whether the RF cable and
port is not tightened;
3) Check whether the TX frequency of the air unit is consistent with the RX frequency of
the ground unit with Viewpro PC management software.
4) Check the TX power of the air unit with Viewpro PC management software.
5) If the above steps can not solve the problem, please contact Viewpro technical support
staff.
Q14: What if the ethernet physical link LED indicator is not on?
Please follow the following steps:
1) Please check whether the power supply of the air and ground unit is normal.
2) Please check whether the RJ45 cable is normal.
3) If the above steps can not solve the problem, please contact Viewpro technical support
staff.
Q15: What if the ethernet data link LED indicator is not on?
Please follow the following steps:
1) Please check whether the ethernet physical link LED indicator is on.
2) Please check whether the cameras, pods and other equipment are working properly.
3) If the above steps can not solve the problem, please contact Viewpro technical support
staff.
Q16: After connecting Viewpro module, telemetry can not be connected properly?
Please follow the following steps:
1) Please check whether the link state is normal, please refer to Question 12 and
Question 13 if it is abnormal.
2) Please check whether the telemetry port both the air and the ground units is correct.
3) Please check whether the connecting between flight controller and air unit is correct
and that between ground unit and ground station is correct.
4) Please check whether the telemetry connection of the air and ground unit is correct.
We provides standard cables. If you make it by yourself, please check the pin.
5) Check whether the baud rate is configured correctly with Viewpro PC management
software.
6) If the above steps can not solve the problem, please contact Viewpro technical support
staff.
