41
Q17: After connecting Viewpro module, RC can not be connected properly?
Please follow the following steps:
1) Please check whether the link state is normal, please refer to Question 12 and
Question 13 if it is abnormal.
2) Please check whether the RC port both the air and the ground units is correct.
3) Please check whether the RC connecting between flight controller and air unit is
correct and that between ground unit and remote controller is correct.
4) If using PPM mode, check the mode configuration of the remote controller; if using S.
BUS mode, check the configuration of the receiver and remote controller;
5) Please check whether the RC connection of the air and ground unit is correct. We
provides standard cables. If you make it by yourself, please check the pin.
6) Please check whether the RC mode is configured correctly with Viewpro PC
management software.
7) If the above steps can not solve the problem, please contact Viewpro technical support
staff.
Q18: After connecting Viewpro module, video can not be output properly?
Please follow the following steps:
1) Please check whether the link state is normal, please refer to Question 12 and
Question 13 if it is abnormal.
2) Please confirm whether the ethernet physical link and the ethernet data link indicators
are normal, if not, please refer to Question 14 and Question 15.
3 )Please confirm the IP address, login username and password of the webcam;
4) Please check whether the IP address configuration of the ground station and the
network camera is in the same network segment;
5) If the above steps can not solve the problem, please contact Viewpro technical
support staff.
Q19: After connecting Viewpro module, what if the video carton or mosaic?
Please follow the following steps:
1) Please confirm whether the downlink mode configuration is reasonable;
2
）
Please check whether the connection of RJ45 network is normal;
3) Please check If there is interference exist, we can consider changing the working
frequency.
4) If there is no interference, whether the limit distance of communication link has been
reached;
