35
Invalid data
All LEDs blinking
Hardware error
All LEDs blinking
Network error
30027
SD card error
30900
40083
SD card missing
40100
Power fault, or Machine
temperature out of valid
range
No lights at all
If one of the events below occur, please follow these instructions:
Paper load error: This could mean, there is not paper present when the embosser is trying to start
printing. It could mean, paper ran out before the print job was completed. Or it could mean, the paper
path is blocked and no top of form could be found to start a new page. In any of these cases, make sure
to have paper loaded properly and press the arrow down button to begin, or continue printing. To cancel
the print job at this point and clear the error, press the cancel button. If any other print job is waiting in
the queue, it will be trying to print now.
Paper Jam: Remove the jammed paper according to the instructions in section VI.B. below, and press
cancel to clear any error status. Now any print job which was not completed before the error occurred
should be resent.
Print data error: If you notice wrong data output from the embosser, press cancel and send the print job
again.
Carriage stall: If the carriage stalls, turn the embosser off and see if the paper path is clear following
instructions in VI.B below to remove jammed paper. Turn the embosser back on. If this does not clear the
error status, contact ViewPlus Support.
Any failure that can't be identified: Turn the embosser off and contact ViewPlus Support.
