2.2
Intended use
2.2.1
Areas of use
The drain is designed for small to medium volumes of water, which
occur in e. g. residential building.
Technical information, see
Ä
Chapter 2.3.2 „Technical data“ on page 8.
The drain is a reconstruction model, which due to its low height can also
be integrated into a very low floor construction without having to make a
drill hole. For this reason, mounting always takes place on the raw con-
crete floor.
The water seal level of 25 mm and the small drainage
capacity do not meet the specifications pursuant to the
standards and regulations. See
Ä
„Regulations from sec-
tion: Fields of application“ on page 6.
Check if the drainage capacity is sufficient before mounting!
2.2.2
Media
The drain is intended for draining of household-type wastewater in con-
stant operation, see
Ä
„Regulations from section: Media“ on page 6.
n
The short-term temperature of the wastewater may reach up to
95° C. The temperature must be considerably lower in constant
operation.
n
The pH value must be higher than 4 but lower than 10.
It is not permitted to introduce wastewater which would damage the
product material.
2.2.3
Drainage capacity
Drainage capacity at an accumulation height of 10 mm above the grate:
0.5 l/s
Drainage capacity at an accumulation height of 20 mm above the grate:
0.55 l/s
10
20
Product information
Advantix Advantix bath drain 62 mm, (reconstruction model)
7 from 21
