Maintenance and Troubleshooting
Vision Model 140/150 Owner’s Operating Manual
89
PRE
L
IMINAR
Y
TIPM (Image Processor)
60
Boot code CRC failed.
61
Unable to program DigMux PLD.
62
Unable to program Control PLD.
63
Unable to program Bubks PLD.
64
Unrecognized ROM type.
65
Write to flash ROM failed.
66
TIPM failure.
67
Downloaded code will not fit.
6
8
Scaler communication problem.
Built-In Keypad
70
Unable to access EEPROM on the built-in keypad.
71
EEPROM memory re-initialization on the built-in keypad.
Panel Driver and Formatter
8
0
Unrecognized Panel Driver.
8
1
Unable to program device on Panel Driver.
8
2
TI flash download failure.
8
3
TI flash download failure.
8
4
TI flash download failure.
8
5
TI-I2C write failure.
8
6
One or more formatters not responding; probable formatter software fault.
8
7
Formatter reports RDRAM failure.
88
Red modular Formatter communication failure.
8
9
Green modular Formatter communication failure.
8
A
Blue modular Formatter communication failure.
93
Modular formatter architecture error.
94
Modular formatter DMD mismatch.
95
Modular formatter sequence mismatch.
Table 5-2. Vision 140/150 Error Codes (continued)
Code
Description
Note:
To clear a system error, press the
EXIT
key (on the projector’s rear-panel keypad) twice. If necessary,
reset the projector by powering it off, allowing it to cool and powering it on again. Contact your Vidikron
dealer or Vidikron technical support if the error persists.
Summary of Contents for 140/150
