V-Tap VoIP Manual EN v2.7 Oct 2018 © 2017-2018 Vidicode 32
•
Red LED steady ON plus Amber LED blinking fast.
A read- or write-error happened on the SD card or the SD card
is not usable by the system. This can only be solved by removing
the card. Then it is also recommended to check the card on an
external PC.
•
Red LED steady
ON with “
Button Start/Stop
” function.
If manual recording with the button is enabled, then the Red
LED ON means that recording is active.
•
Red LED blinking plus Green LED blinking.
The system cannot connect to the Tunnel server.
See also
Green LED blinking
below.
•
Red LED blinking once per second.
This happens when you take out the SD card while the system
was still busy writing to it. So, an unclosed (0 bytes) file is now
on the card. See also
Remove SD Card safely
.
•
Red LED blinking fast.
This indicates that data was lost. The internal buffer was
overflown, because the connection to the Tunnel server was lost
or writing to the SD card failed. This situation can solve itself
after connection to the Tunnel server has been restored.
•
Red LED blinking fast,
together with all other LED’s.
This happens after a fatal error in the application. The firmware
must be updated.
4.2
Green Link LED
The Green LED shows the status of the link to the Tunnel server.
•
Green LED blinking.
The system tries to connect to the Tunnel server. This can last
forever, but normally it should take a few seconds after reset.
When longer, the Tunnel server could not be found, or the
network connection is bad. The Red LED also starts blinking in
that case. Check the firewall on the PC or switch!
The Green LED goes to steady ON when the connection is made.
