Videx Kristallo KRV772, Installation Instructions Manual

Page: 5 / 16

66250965 - V4.0 - 31/05/19
- 5 -
Kristallo Series
Art. KRV772 - Installation instructions
REMOVE THE BACK COVER
Fig. 1 Fig. 2 Fig. 3
1. To install the videophone, it is necessary to remove the back cover. Apply pressure to the two clips indicated by the grey arrows
(
Fig. 1
) using fingers (
Fig. 2
) while lightly pulling the upper part in the direction of the white arrows (
Fig. 3)
.
N.B. Repeat the same operation with both clips.
FLUSH MOUNTING INSTRUCTIONS
135cm
Fig. 4 Fig. 5
1
1
2
2
Fig. 6 Fig. 7
1. First of all remove the back cover as described above;
2. Protect the holes to fix the videophone to the flush mounting box then embed the flush mounting box in line with the wall
in a
horizontal position
at 135cm height from the floor as shown in
Fig. 4
;
3. As shown in
Fig. 5
, fix the back cover of the videophone to the flush mounting box keeping the same orientation shown in the
figure and taking care to feed the connection cables through the specific circular opening;
4. Connect the wires using a flat screw driver then setup the dip-switches as per provided connection diagram or instruction sheet
and fix the front part of the videophone to the back cover as shown in
Fig. 6
: hook first the bottom side then rotate the front part
and hook the upper side;
In order to avoid malfunctions, please do not over tighten the screws.
5. The video intercom is installed ( Fig. 7 ), power up the system and check that it works correctly.
Kristallo Series
7" flush and surface videomonitor wall mounting instructions