Videotec DCIR, Operating Instructions Manual

Page: 24 / 68

Pag. 4 DCIR_4402
Devices controlled by the DCIR remote control
Video matrix models:
•
SM42A, SM82A, SM84A, SM164A (which also allow telemetry transmission via coaxial cable)
•
LXRPS42A / LXRPS82A / LXRPS42TA / LXRPS82TA / LXRPS84A / LXRPS164A
Completely controllable telemetry receivers:
•
MICRODEC485
•
DTMRX1
•
DTRX3 (controllable by DCIR and SM series matrixes using telemetry over the coax).
Partly controllable telemetry receivers:
•
DTRXDC (all functions can be controlled but speed of pan & tilt movements cannot be varied)
Installation
The following procedures must be carried out with power supply off, if not otherwise specified .
The installation must be carried out only by qualified technical staff .
Unpacking
If the packing shows no relevant defects due to falls or anomalous abrasions, check the material contained,
according to the list given at chapter
Introduction, Packing contents (page 2).
The installer technician is required to dispose of the packing material according to the differentiated collecting
modalities or, anyway, according to the normative laws in force in the Country of use.
Check of identification data
Before installing the appliance, check that the material supplied corresponds to the specifications
indicated on the data plate, following the chapter Identification data (page 3). Do not carry out any modification
or connections, which are not provided for in this manual: the use of improper appliances may seriously
compromise the safety of the personnel and the installation.
Switching on and off
Before connecting the appliance:
•
check that the material supplied corresponds to the specifications indicated on the data plate, following the
chapter Identification data (page 3)
•
check that the remote control and the other components of the installation are closed in order to avoid a
direct contact with energized parts
•
the remote control base and the other appliances of the installation must rest on a large and solid base
•
the power supply cables do not have to hinder the common operations of the installer technician
•
check that the electrical capacity and the extensions eventually used will support the power consumption of
the system.
SWITCHING ON : connect via telephone cable the remote control base to the matrix; supply power to
the matrix. It is also possible to power the remote control base using an external 12V
=
power supply (not
equipped); see page 8.
SWITCHING OFF : disconnect the remote control base from the matrix.